With the increasing use of excavators, more and more projects are gradually adapted to the existence of such equipment. But with the use of excavators, the loss of bucket teeth of excavators is also increasing, so how should we operate when using excavators in ordinary times to make more effective use of bucket teeth of excavators?
The importance of bucket teeth of excavators is self-evident, so more attention should be paid to it when it is used. Correct measures must be taken so that the use of excavators will be normal. Then, how to use the bucket teeth of excavator correctly? Here is an introduction for you.
Correct selection: first of all, the use of bucket teeth of excavators should be correctly selected, and the determination of material needs to be carried out according to the environment. Only in this way can the correct selection be better guaranteed, and the correct selection of bucket teeth in use can also play the best performance.
Attention to angle: Excavator driver should pay attention to the angle of excavation during operation. When excavating, the bucket teeth are vertical to the working face, or the dip angle is not more than 120 degrees, so as to avoid breaking the bucket teeth due to the excessive dip angle. Also pay attention not to swing the excavating arm left and right in the case of greater resistance, which will cause the bucket teeth and the teeth seat to break because of the excessive left and right force, because most types of bucket teeth mechanical design principle, do not consider the left and right force design.
Timely replacement: The wear condition of the tooth base is also very important for the service life of bucket teeth of excavators. It is suggested that the tooth base be replaced after 10%-15% wear. Because there is a large gap between the worn tooth base and bucket teeth, the matching between bucket teeth and bucket teeth and the stress point have changed. The bucket teeth are broken because of the change of the stress point.
Huangzuan Machinery established in 2008, is a specialized manufacturer of bucket teeth, bucket adaptor and side cutter which is used Caterpillar, Komatsu, Hyundai, Daewoo, Kobelco, Hensley, Liugong, Hitachi, XCMG, XGMA, Volvo, JCB .etc.
With production facilities covering an area of 18136 square meters and staff of 100, our annual processing capability equals approximately 12,000 metric tons. we currently have the technology of lost wax casting, precoated sand casting, resin sand casting, have the advanced instrument such as spectromaxx, Brinell hardness tester, universal testing machine, metalloscope.